User Manual

102 Part 003609A revision 01 December 16, 2002
Amosphere NPM Installation Procedures (WCS)
 To connect the Ethernet cables
1 Connect the Ethernet cables to the Ethernet switches. Table 4.15 shows the origin
and termination point of each cable.
 If you are using an edge router configuration without redundancy, connect
Ethernet switch 0 to the edge router by connecting port 1 on the right ES rear
I/O card (slots 19–20) to the edge router. Use a straight-through Ethernet
cable.
 If you are using an edge router configuration with redundancy:
i Connect Ethernet switch 0 to the edge router by connecting port 1 on the
right ES rear I/O card (slots 6–7) to port 0 on the edge router.
ii Connect Ethernet switch 1 to the edge router by connecting port 1 of the
left ES rear I/O card (slots 19–20) to port 1 on the edge router.