User Manual

December 16, 2002 Part 003609A revision 01 93
Chapter 4: Installation Procedures
C ONNECTING THE C ABLES
This section describes the cables connecting the different systems in the NPM.
Table 4.10 shows the actions described in this section.
NOTE: The cables are packaged according to their type. Each
cable package is labeled with a part number. Use this part
number to identify each cable, and refer to the tables provided in
this section for its intended origin and termination point.
Depending on the configuration of your NPM, the exact number
and layout of the cards may vary. See your E1 package for the
specific layout.
Action Page
Connect the PDP Power Cables 94
Connect the RFSS Signal Cables 98
Connect the Alarm Cables 100
Connect the Ethernet Cables 101
Connect the Clock Cables 103
Connect the RF Cables 105
Table 4.10 Connecting the Cables Procedure Summary