User Manual

60 Part 003609A revision 01 December 16, 2002
Amosphere NPM Installation Procedures (WCS)
vi Ensure that the anchor bolt, spacer sleeve, expansion sleeve, and expansion
cone do not have any slack. If any of these parts are loose, tighten the parts
by hand to remove any slack. Do not start spreading the expansion sleeve.
vii Place a hold-down plate over the holes in the base of each rack.
viii Loosely insert the anchor bolts through the hold-down plates into the base of
the rack and the anchor holes. If necessary, tap the top of each anchor bolt to
ensure it is fully seated.
ix Tighten the four anchor bolts in the base of each rack by turning the 3/4-inch
washer nut while holding the 1/4-inch anchor bolt in place. The expansion
sleeve is forced open, which secures the rack to the floor.
x Reattach the lower cooling units to each frame using the 5/16-inch screws.
Torque the screws to 50 inch-pounds.
xi Reattach the front grill to each frame using the grill’s two half-turn screws. The
screws are vertical when open and horizontal when locked.