User Manual

52 Part 003609A revision 01 December 16, 2002
Amosphere NPM Installation Procedures (WCS)
 To configure the application hosts
1 Remove the application hosts from their antistatic packaging at a grounded work
area. Ensure that you are properly grounded with a wrist or boot strap before
handling the cards. Depending on the configuration of your NPM, you may have
up to eight application hosts that need to be configured.
2 On each card, set SW3-3, SW3-4, and SW2-4 to the closed (ON) position. Figure
3.3 shows the locations of the switches.
Figure 3.4 Application Host Switch Configuration
3 Ensure that the other switches are configured as shown in Table 3.7.
4 Place the cards back in their antistatic packaging until you are ready to install them
in the shelves.
00327
Closed (ON)
Open (OFF)
SW3
Closed (ON)
Open (OFF)
SW2
Closed (ON)
Open (OFF)
SW4