User Manual

50 Part 003609A revision 01 December 16, 2002
Amosphere NPM Installation Procedures (WCS)
 To configure the controller cards
1 Remove cards from their antistatic packaging at a grounded work area. Ensure
that you are properly grounded with a wrist or boot strap before handling the
cards. Depending on the configuration of your NPM, you may have up to eight
cards that need to be configured.
2 On each card, set the SW6-1 switch to the closed (ON) position. Figure 3.3 shows
the location of the switch.
Figure 3.3 Controller Card Switch Configuration
3 Ensure that the other switches are configured as shown in Table 3.6.
4 Place the cards back in their antistatic packaging until you are ready to install them
in the shelves.
00326
Closed (ON)
Open (OFF)
E
N
E
T
B
E
N
E
T
A
A
B
100 M
b
U
S
B
V
G
A
RUN
SM
IDE
USR
1
ALARM
C
UTO
FF
M
IN
M
AJ
CR
T
A
CO
TAKE
PW
R
US
R
2
RE
SET
C
O
M
1
SW6