User Manual

48 Part 004071A revision 00b August 6, 2003
Amosphere NPM Installation Procedures (MMDS)
 To configure the Ethernet switches
1 Remove the two Ethernet switches from their antistatic packaging at a grounded
work area. Ensure that you are properly grounded with a wrist or boot strap before
handling the cards.
2 Remove the K1 PCI Reset jumper from each card. Figure 3.2 shows the location
of the jumper.
Figure 3.2 Ethernet Switch Jumper Configuration
3 Hang the jumper off the header pins as shown in Table 3.5. This ensures that the
jumper is still present if future changes to the cards are required.
4 Ensure that jumpers K2 to K7 are configured as shown in Table 3.5.
5 Place the cards back in their antistatic packaging until you are ready to install them
in the shelves.
00275
K1 PCI Reset Jumper
K7 CPCI BDSEL
installation.book Page 48 Wednesday, August 6, 2003 6:06 PM