User Manual

August 6, 2003 Part 004071A revision 00b 89
Chapter 4: Installation Procedures
C ONNECTING THE C ABLES
This section describes the cables connecting the different systems in the NPM
basestation. Table 4.10 shows the actions described in this section.
NOTE: The cables are packaged according to their type. Each
cable package is labeled with a part number. Use this part
number to identify each cable, and refer to the tables provided in
this section for its intended origin and termination point.
Depending on the configuration of your basestation, the exact
number and layout of the cards may vary. See your field
engineering package (FEP) for the specific layout.
Action Page
Connect the PDP Power Cables 90
Connect the RFSS Signal Cables 94
Connect the Alarm Cables 96
Connect the Ethernet Cables 97
Connect the Clock Cables 99
Connect the RF Cables 101
Table 4.10 Connecting the Cables Procedure Summary
installation.book Page 89 Wednesday, August 6, 2003 6:06 PM