User Manual

110 Part 004071A revision 00b August 6, 2003
Amosphere NPM Installation Procedures (MMDS)
each 7/16 DIN connector to 17 foot-pounds and ensure each connector
is properly weatherproofed.
iv Connect the BTS port on each bias tee to the ANT port on each RFSS
module. The ANT port is located on the rear side of the RFSS module.
v Connect the CIN port (also called Vout) on the rear side of the RFSS
module to the DC port on the bias tee.
!
CAUTION: Do not over-tighten connectors. Overtightening the
connectors may damage the cable and degrade the RF signal.
installation.book Page 110 Wednesday, August 6, 2003 6:06 PM