User Manual

August 6, 2003 Part 004071A revision 00b 123
Chapter 6: On-Site Software Installation and Configuration Procedures
 To configure the Ethernet switches
1 Establish a serial connection with the Ethernet switch:
i Connect a PC to the Ethernet switch using the supplied RJ-11 to DB-9 serial
cable with a null modem adapter. See Table 6.2 for pin assignments.
ii Start a serial terminal session using the settings shown in Table 6.3.
2 Log in to the Ethernet switch.
3 Restore the default settings for the Ethernet switch by typing:
switch defaults ↵
The Ethernet switch reboots.
4 Log in to the Ethernet switch.
5 Configure the switch by typing:
port config 1-2 off 100 full false ↵
port config 3-24 off 100 half false ↵
span port enable 1-26 on ↵
span port fast 1-26 on ↵
bootp enable off ↵
dhcp server enable off ↵
dhcp client enable switch_name off ↵
cos queuing algorithm strict ↵
cos queuing map 0 0 ↵
cos queuing map 1 0 ↵
cos queuing map 2 0 ↵
cos queuing map 3 0 ↵
cos queuing map 4 1 ↵
cos queuing map 5 2 ↵
cos queuing map 6 3 ↵
cos queuing map 7 3 ↵
gvrp enable off ↵
ip config switch_name switch_ip_address 255.255.255.0 1 ↵
ip gateway router0-0_ip_address ↵
tftpd sessions 0 ↵
save ↵
Parameter Setting
Baud 9600 bits/s
Data bits 8
Parity None
Stop bits 1
Flow control None
Table 6.3 Ethernet Switch Serial Port Settings
installation.book Page 123 Wednesday, August 6, 2003 6:06 PM