Installation Manual

August 23, 2006 Revision 00b-DRAFT 29
Chapter 4: Installation Procedures
Configure Jumpers on Sector Controller
A Concurrent 310 card is used for the sector controller. It may be necessary to modify the jumper
settings, as the base station uses a configuration of these cards that differs from the manufacturer’s
original settings.
NOTE: If the card is pre-installed in the chassis, then it has already been configured
and this procedure is not required.
Jumper Settings
Table 4.1 shows the required settings of the configuration switches that differ from the factory
defaults.
 To configure the Concurrent PP310 Jumper Settings
1 Remove the card from its antistatic packaging at a grounded work area. Ensure that you are properly
grounded with a wrist or boot strap before handling the cards. Depending on the configuration of your
base station, you may have up to eight cards that need to be configured.
2 Ensure that the jumper switches are configured as shown in Table 4.1. Figure 4.2 shows the location of
the jumpers.
Switch Appearance Description
Console Mode → Serial console mode Directs the console to the serial port
User/Test → Restore user
defaults/soak
Restores BIOS settings from NVRAM in case of
corruption rather than factory defaults
Table 4.1 Concurrent 310 Switch Settings