Installation Manual

August 23, 2006 Revision 00b-DRAFT 27
Chapter 4: Installation Procedures
Install the Radio Modules
Two radio modules are used per sector, main and diversity.
Figure 4.1 Radio Module Insertion
 To install the radio modules
1 Remove the radio module from its protective bag.
2 Orient the radio module properly.
3 Slide the radio module into the first available radio module slot. The slots should be filled from left to right,
then top to bottom.
4 Ensure that the radio module is anchored into the guide shoe in the back of the radio module shelf.
Figure 4.1 shows how to anchor the radio module into the guide in the back of the radio module shelf.
5 Secure the module in the slot using four thumb screws, one in each corner. Torque the thumb screws to
1.5 N•m (13 inch-pounds).
6 Ensure that the radio module is secure by grasping the handle on the front panel and pulling lightly. The
radio module should not move. If the radio module does move, ensure that the thumb screws are
attached to the shelf assembly and that the module is seated correctly. If necessary, remove the module
and repeat this procedure.
7 Repeat steps 1 to 6 for the second radio module.
8 Cover any empty slots in the radio module shelf with filler panels.\
E
X
T
/L
N
A
SE
R
D
E
S
UA
RT
A
N
T
E
S
F
U
UART
EXT/LNA
SERDES
ANT
LO OUT
LO IN
POWER SUPPLY