Installation Manual

August 23, 2006 Revision 00b-DRAFT 23
Chapter 3: Pre-Installation Requirements and Procedures
Unpack and Inspect the Equipment
Once you received your base station equipment, use the following procedure to ensure you have all the
necessary parts.
 To unpack and inspect the base station equipment
1 Transport the shipping boxes to the installation area using a dolly or pallet jack.
2 Inspect the exterior packaging for any noticeable damage that may have occurred during shipment.
3 Unpack the equipment. If a component is packed in anti-static packaging, leave the component inside
the packaging until you are ready to install it.
4 Check the equipment for extra mounting hardware or invoices. If there are additional items, remove them
and keep them for future use.
5 Save the packaging material and the BOMs in case any of the equipment needs to be returned or moved
in the future.
6 Ensure that all equipment and accessories have been shipped.
7 Document any shortages and report them to your SOMA Networks representative so that any missing
equipment may be procured and delivered to the site as soon as possible.
8