User's Manual

24
Booster Antenna Installation Guide
7
Hold the mounting bracket and pipe assembly over the holes so that the short
end of the mounting pipe points up.
If the mounting bracket spans two pieces of siding, use a spacer.
The mounting bracket should be positioned so that most of it is on the top board. A
spacer should be installed to help hold the bottom of the mounting bracket in
place. The spacer can be made of either solid wood or plastic.
INSERT Diagram
8
Insert a 5/16-inch x 2-inch lag screw in each of the holes to attach the mounting
bracket to the roof.
9
Tighten the screws enough to hold the mounting bracket and pipe assembly in
place.
10
Adjust the mounting pipe so that it points straight up.
i
Use a socket to loosen the three carriage bolts on the mounting bracket near
the pipe, as shown in the following illustration.
Insert Diagram
ii
Hold the mounting pipe and twist it until the short end of the pipe (on which
the booster antenna will rest) is perfectly vertical.
iii
Tighten the three bolts to hold the mounting pipe securely in a vertical
position.
Diagram showing a correct installation with the booster antenna pointing straight
up.
11
Tighten the screws that secure the bracket to the side of the building.
12
Attach the booster antenna to the mounting assembly.
For more information, see “Attaching the booster antenna to the mounting
assembly” on page 28.

To install a spacer
1