User's Manual

22
Booster Antenna Installation Guide
7
Fill all four holes with silicone sealant.
8
Hold the mounting bracket and pipe assembly over the holes.
9
Insert a 5/16-inch x 2-inch lag screw in each of the holes to attach the mounting
bracket to the roof.
10
Tighten the screws enough to hold the mounting bracket and pipe assembly in
place.
11
Adjust the mounting pipe so that it points straight up.
i
Use a socket to loosen the three carriage bolts on the mounting bracket near
the pipe, as shown in the following illustration.
Insert Diagram
ii
Hold the mounting pipe and twist it until the short end of the pipe (on which
the booster antenna will rest) is vertical.
iii
Tighten the three bolts to hold the mounting pipe securely in a vertical
position.
Diagram showing a correct installation with the booster antenna pointing straight
up.
12
Tighten the screws that secure the bracket to the roof.
13
Seal the mounting bracket with roof sealant.
When applying the sealant, make sure you seal the areas shown in the figure
below.
Diagram showing where sealant goes.
14
Attach the booster antenna to the mounting assembly.
For more information, see “Attaching the booster antenna to the mounting
assembly” on page 28.