User's Manual
Table Of Contents
- Overview
- The Front Panel
- The Back Panel
- The Internal Antenna
- Introduction
- Installing the SOMAport
- Connecting Multiple Computers
- Overview
- Using an Ethernet Hub
- Using an Internet Router
- Finding Causes of Computer Problems
- Finding Causes of Telephone Problems
- The Signal is Weak
- There is a Fault Condition
- The SOMAport is Not Receiving Power
- There is a Problem with the Ethernet or USB Cabling
- There is a Problem with the USB Port Settings
- The Computer Uses an Old Dial-Up Connection
- Internet Explorer LAN Settings are Incorrect
- Ethernet Network Settings are Incorrect
- IP address Needs to be Renewed
- Troubleshooting
- Specifications
- Index
36
THE SOMAPORT IS NOT RECEIVING POWER
If the light on the power supply and the status light on the SOMAport
are off, the SOMAport is not getting power. Try each of the actions in
the following procedure until you locate the source of the problem.
To check the power
1 Make sure the power cord that connects the power supply to the wall outlet
is securely connected to the power supply and the wall outlet.
2 Make sure the power cord that connects the power supply to the SOMAport
is securely connected to the power jack on the back of the SOMAport.
3 Make sure the wall receptacle is working by plugging in an appliance that
you know works.
4 Check the circuit breaker.
5 If you cannot find the source of the problem, call your service provider.
sp3.book Page 36 Tuesday, March 28, 2006 5:09 PM