User's Manual
Table Of Contents
- Overview
- The Front Panel
- The Back Panel
- The Internal Antenna
- Introduction
- Installing the SOMAport
- Connecting Multiple Computers
- Overview
- Using an Ethernet Hub
- Using an Internet Router
- Finding Causes of Computer Problems
- Finding Causes of Telephone Problems
- The Signal is Weak
- There is a Fault Condition
- The SOMAport is Not Receiving Power
- There is a Problem with the Ethernet or USB Cabling
- There is a Problem with the USB Port Settings
- The Computer Uses an Old Dial-Up Connection
- Internet Explorer LAN Settings are Incorrect
- Ethernet Network Settings are Incorrect
- IP address Needs to be Renewed
- Troubleshooting
- Specifications
- Index
25
To connect two telephones (when you have one line)
1 Insert a dual-jack extension cord or adapter into the line 1 (bottom) jack of
the SOMAport.
2 Insert the free end of one telephone cable into one of the jacks on the
adapter.
3 Insert the free end of the second telephone cable into the other jack on the
adapter.
To test your SOMAport telephone service
Pick up the receiver and listen for dial tone.
If you hear a standard dial tone, the SOMAport is connected to your service
provider’s network. You may have to activate full service if your service
provider hasn’t done so already. See “Activate Service” on page 26.
If you hear a series of tones, the SOMAport is still starting. Hang up, and
listen again in a few minutes.
If you hear silence, see “Finding Causes of Telephone Problems” on
page 33.
sp3.book Page 25 Tuesday, March 28, 2006 5:09 PM