User's Manual
Table Of Contents
- Overview
- The Front Panel
- The Back Panel
- The Internal Antenna
- Introduction
- Installing the SOMAport
- Connecting Multiple Computers
- Overview
- Using an Ethernet Hub
- Using an Internet Router
- Finding Causes of Computer Problems
- Finding Causes of Telephone Problems
- The Signal is Weak
- There is a Fault Condition
- The SOMAport is Not Receiving Power
- There is a Problem with the Ethernet or USB Cabling
- There is a Problem with the USB Port Settings
- The Computer Uses an Old Dial-Up Connection
- Internet Explorer LAN Settings are Incorrect
- Ethernet Network Settings are Incorrect
- IP address Needs to be Renewed
- Troubleshooting
- Specifications
- Index
12
Status Light
The status light indicates whether or not the SOMAport is powered on
and operating normally.
Network Light
The signal strength light indicates if the SOMAport has located a
basestation.
State Description
Off The SOMAport is not receiving power.
Amber The SOMAport is booting and running its internal
diagnostics.
Flashing amber The SOMAport is upgrading its firmware. DO NOT unplug
the SOMAport when this light is flashing. Disconnectng or
powering off the SOMAport during a firmware upgrade may
damage the unit and render it nonfunctional.
Green The SOMAport is powered and operating normally.
Red An error occurred. The SOMAport is not currently functional.
State Description
Off The SOMAport is not receiving power.
Amber The SOMAport is attempting to locate a basestation.
Flashing amber The SOMAport cannot locate a basestation.
Flashing green The SOMAport has located a basestation and is attempting
to establish a connection.
Green The SOMAport has located a basestation and has
established a connection.
Red An error occurred. The SOMAport is not currently functional.
sp3.book Page 12 Tuesday, March 28, 2006 5:09 PM