User's Manual
Table Of Contents
- Overview
- The Front Panel
- The Back Panel
- The Internal Antenna
- Introduction
- Installing the SOMAport
- Connecting Multiple Computers
- Overview
- Using an Ethernet Hub
- Using an Internet Router
- Finding Causes of Computer Problems
- Finding Causes of Telephone Problems
- The Signal is Weak
- There is a Fault Condition
- The SOMAport is Not Receiving Power
- There is a Problem with the Ethernet or USB Cabling
- There is a Problem with the USB Port Settings
- The Computer Uses an Old Dial-Up Connection
- Internet Explorer LAN Settings are Incorrect
- Ethernet Network Settings are Incorrect
- IP address Needs to be Renewed
- Troubleshooting
- Specifications
- Index
11
THE FRONT PANEL
There are two lights on the front panel that indicate the state of the
SOMAport: status and network.
NOTE: DO NOT unplug the SOMAport when the Status
light is flashing amber. The Status light flashes amber during
sensitive firmware upgrades only. Disconnectng or powering
off the SOMAport during a firmware upgrade may damage
the unit and render it nonfunctional.
Status Light
Network Light
sp3.book Page 11 Tuesday, March 28, 2006 5:09 PM