User's Manual
Table Of Contents
- Overview
- The Front Panel
- The Back Panel
- The Internal Antenna
- Introduction
- Installing the SOMAport
- Unpack the SOMAport
- Choose the Best Location
- Power on the SOMAport
- Connect Computer Using Ethernet
- Connect Computer Using USB
- Connect Multiple Computers to the SOMAport
- Connect Telephones to the SOMAport
- Activate Service
- Finding Causes of Computer Problems
- Finding Causes of Telephone Problems
- The Signal is Weak
- There is a Fault Condition
- The SOMAport is Not Receiving Power
- There is a Problem with the Ethernet or USB Cabling
- There is a Problem with the USB Port Settings
- The Computer Uses an Old Dial-Up Connection
- Internet Explorer LAN Settings are Incorrect
- Ethernet Network Settings are Incorrect
- IP address Needs to be Renewed
- Troubleshooting
- Specifications
- Index
40
INTERNET EXPLORER LAN SETTINGS ARE
INCORRECT
If you are using Internet Explorer as your Web browser, make sure it is
configured to automatically detect LAN settings. If this default setting
has been disabled, you will not be able to connect to the Internet.
To check Internet Explorer settings
1 Open Internet Explorer.
2 Choose Tools→Internet Options.
The Internet Options window opens.
3 Click the Connections tab.
4 Click LAN Settings.
The Local Area Network (LAN) Settings window opens.
5 Make sure the Automatically detect settings checkbox is enabled.
6 Click OK.
7 Click OK on the Internet Options window.
8 Close Internet Explorer.
sp3.book Page 40 Thursday, July 22, 2004 3:21 PM