User's Manual
Table Of Contents
- Overview
- The Front Panel
- The Back Panel
- The Internal Antenna
- Introduction
- Installing the SOMAport
- Unpack the SOMAport
- Choose the Best Location
- Power on the SOMAport
- Connect Computer Using Ethernet
- Connect Computer Using USB
- Connect Multiple Computers to the SOMAport
- Connect Telephones to the SOMAport
- Activate Service
- Finding Causes of Computer Problems
- Finding Causes of Telephone Problems
- The Signal is Weak
- There is a Fault Condition
- The SOMAport is Not Receiving Power
- There is a Problem with the Ethernet or USB Cabling
- There is a Problem with the USB Port Settings
- The Computer Uses an Old Dial-Up Connection
- Internet Explorer LAN Settings are Incorrect
- Ethernet Network Settings are Incorrect
- IP address Needs to be Renewed
- Troubleshooting
- Specifications
- Index
33
THERE IS A FAULT CONDITION
If the status light is red, the SOMAport has detected a fault. In this
situation, restart the SOMAport.
To restart the SOMAport
1 Unplug the SOMAport from the wall power outlet and wait at least 10
seconds.
2 Plug the SOMAport back in.
3 Wait until the status light on the front panel is green (an indication that the
SOMAport is operating correctly).
If the status light still indicates a problem, call your service provider.
sp3.book Page 33 Thursday, July 22, 2004 3:21 PM