User's Manual
Table Of Contents
- Overview
- The Front Panel
- The Back Panel
- The Internal Antenna
- Introduction
- Installing the SOMAport
- Unpack the SOMAport
- Choose the Best Location
- Power on the SOMAport
- Connect Computer Using Ethernet
- Connect Computer Using USB
- Connect Multiple Computers to the SOMAport
- Connect Telephones to the SOMAport
- Activate Service
- Finding Causes of Computer Problems
- Finding Causes of Telephone Problems
- The Signal is Weak
- There is a Fault Condition
- The SOMAport is Not Receiving Power
- There is a Problem with the Ethernet or USB Cabling
- There is a Problem with the USB Port Settings
- The Computer Uses an Old Dial-Up Connection
- Internet Explorer LAN Settings are Incorrect
- Ethernet Network Settings are Incorrect
- IP address Needs to be Renewed
- Troubleshooting
- Specifications
- Index
25
To connect two telephones (when you have two lines)
1 Connect the cable of the telephone you want serviced by line 1 to the line 1
(bottom) jack on the SOMAport.
2 Connect the cable of the telephone you want serviced by line 2 to the line 2
(top) jack on the SOMAport.
NOTE: If you have a two-line telephone, connect it to the line 1 (bottom)
jack.
Line 2
Line 1
sp3.book Page 25 Thursday, July 22, 2004 3:21 PM