User's Manual
Table Of Contents
- Overview
- The Front Panel
- The Back Panel
- The Internal Antenna
- Introduction
- Installing the SOMAport
- Unpack the SOMAport
- Choose the Best Location
- Power on the SOMAport
- Connect Computer Using Ethernet
- Connect Computer Using USB
- Connect Multiple Computers to the SOMAport
- Connect Telephones to the SOMAport
- Activate Service
- Finding Causes of Computer Problems
- Finding Causes of Telephone Problems
- The Signal is Weak
- There is a Fault Condition
- The SOMAport is Not Receiving Power
- There is a Problem with the Ethernet or USB Cabling
- There is a Problem with the USB Port Settings
- The Computer Uses an Old Dial-Up Connection
- Internet Explorer LAN Settings are Incorrect
- Ethernet Network Settings are Incorrect
- IP address Needs to be Renewed
- Troubleshooting
- Specifications
- Index
20
CONNECT COMPUTER USING USB
If your computer does not have an Ethernet port and it is running
Windows 98SE, ME, 2000, or XP, you can use the supplied USB cable
to connector your computer to the SOMAport.
NOTE: Ethernet is the preferred type of connection. The USB connection
should only be used in computers that do not support Ethernet.
To connect a computer via USB
1 Insert the SOMAport USB Drivers CD into the CD-ROM drive on the
computer.
2 Plug the square connector on the USB cable into the USB port on the back
of the SOMAport.
3 Plug the flat connector into the USB port on your computer.
A hardware wizard window opens.
sp3.book Page 20 Thursday, July 22, 2004 3:21 PM