User's Manual
Table Of Contents
- Overview
- The Front Panel
- The Back Panel
- The Internal Antenna
- Introduction
- Installing the SOMAport
- Unpack the SOMAport
- Choose the Best Location
- Power on the SOMAport
- Connect Computer Using Ethernet
- Connect Computer Using USB
- Connect Multiple Computers to the SOMAport
- Connect Telephones to the SOMAport
- Activate Service
- Finding Causes of Computer Problems
- Finding Causes of Telephone Problems
- The Signal is Weak
- There is a Fault Condition
- The SOMAport is Not Receiving Power
- There is a Problem with the Ethernet or USB Cabling
- There is a Problem with the USB Port Settings
- The Computer Uses an Old Dial-Up Connection
- Internet Explorer LAN Settings are Incorrect
- Ethernet Network Settings are Incorrect
- IP address Needs to be Renewed
- Troubleshooting
- Specifications
- Index
13
THE BACK PANEL
The jacks and ports for connecting other devices to the SOMAport are
on the back panel, as shown below.
Part Description
Ethernet port Use this port with the supplied Ethernet cable
to connect the SOMAport to a computer or
hub. This is the preferred type of Internet
connection.
USB port Use this port with the supplied USB cable to
connect the SOMAport to a computer. This
type of connection is intended for use with
computers that do not have an Ethernet port.
Telephone
jacks
Use these jacks to connect telephones to the SOMAport.
Power jack Use this jack to connect the power supply.
Ethernet Port
USB Port
Power Jack
Telephone Jack (Line 2)
Telephone Jack (Line 1)
sp3.book Page 13 Thursday, July 22, 2004 3:21 PM