User Manual
Table Of Contents
- Introduction
- Installing the SOMAport
- Installing the SOMAport and Connecting Equipment
- An overview of the installation
- Unpacking the SOMAport
- Choosing the best location for the SOMAport
- Connecting the power supply and powering on the SOMAport
- Connecting a computer via Ethernet
- Connecting a computer via USB
- Connecting multiple computers to the SOMAport
- Connecting telephones to the SOMAport
- Activating service
- Changing Ethernet Network Settings
- Installing the SOMAport and Connecting Equipment
- SOMAport Lights
- Troubleshooting and Getting Help
- Index
31
Installing the SOMAport
If these drivers are not listed, there are two possible reasons:
You have a USB Host Controller card installed in your PC, but the USB port is
not enabled. See your computer’s documentation for instructions on how to
run your computer’s BIOS Setup program to enable the USB port.
You do not have a USB Host Controller card installed in your PC. You cannot
use USB unless you purchase a USB Host Controller card.
To connect a computer to the USB port on the SOMAport
1
Insert the SOMAport Documentation and USB Drivers CD into the CD-ROM
drive on the computer.
The SOMAport Documentation window opens.
2
Plug the square connector on the USB cable into the USB port on the back of
the SOMAport.
3
Plug the flat connector into the USB port on your computer.
A hardware wizard window opens.
00268