User Manual

30 Proprietary and Confidential
Connecting telephone equipment to in-building telephone wiring
Installing the SOMAport 140
b
Insert the other end of the cable into the wall phone jack.
4
For each telephone device you want to connect to the SOMAport 140 via the
wiring, insert the device’s RJ-11 cable into the wall phone jack.
5
Connect any other equipment to the SOMAport 140 using the proper
procedures.
6
Turn on the SOMAport 140.

To connect to Line 2
Use this method if you want to use in-building wiring and have two phone lines.
1
Plug a two-line splitter into the wall phone jack.
2
Plug a phone into the Line 2 jack (the one on the right if you have a 2-jack
splitter, or in the middle if you have a 3-jack splitter).
3
Check for dial tone.

If you get dial tone, call the phone company and have them disconnect phone
service on Line 2. The SOMAport 140 will not work if the line is still connected
to the phone company. Then go to step
4
.

If you do not get dial tone, go to step
4.
4
Connect the SOMAport 140 to the in-building wiring.
a
Insert one end of the RJ-11 cable into an RJ-11 jack on the SOMAport 140.
00102