Installation Instructions

MANUFACTURER

of Decorative Privacy Window Films

INSTALLATION GUIDE ADHESIVE

Congratulations on your Decorative Films purchase! With the right preparation and

installation, our lms are a fast and easy way to transform a room. For a beautiful and

resilient end result, take your time and follow these directions. Before proceeding, we

strongly recommend visiting our website to read the in-depth instructions, watch our

installation video, and review FAQs. Use the camera on your phone to scan the QR code

or visit DecorativeFilm.com/Installation-Instructions.

MAKE A WETTING SOLUTION

Wetting solution is the secret ingredient to a smooth, seamless installation. Make a

solution by adding 8-10 drops of a mild, non-moisturizing dish detergent (Dawn or Joy;

do not use hand soap) to a 32-oz. spray bottle lled with clean water. Adjust ratio for

smaller or larger bottles. Mix well.

MAKE SURE IT’S SMOOTH

To ensure the surface is completely clean and smooth before installation, spray the glass

with the soapy water mixture and drag a single-edge razor across the surface. If you hear

a clicking sound, there is something on the surface that will prevent full adhesion. Use a

glass-safe scrub pad to remove the debris.

MAKE A WORKSPACE

You will need enough at surface to lay out the lm for measuring, cutting, marking and

prep. Do not run a fan near the lm or glass surface during installation. This can cause

dust and debris to blow onto your lm and become trapped.

DECORATIVEFILM.COM Request FREE Samples // Place an Order

Before you

get started...

PAGE 1
I N S T A L L A T I O N G U I D E A D H E S I V E M A N U F A C T U R E R of Decorative Privacy Window Films Congratulations on your Decorative Films purchase! With the right preparation and installation, our films are a fast and easy way to transform a room. For a beautiful and resilient end result, take your time and follow these directions. Before proceeding, we strongly recommend visiting our website to read the in-depth instructions, watch our installation video, and review FAQs.
PAGE 2
INSTALL ATION GUIDE A D H E S I V E I N S T R U C T I O N S 1 MEASURE, CUT AND CLEAN 2 PEEL AND PREP 3 GET IT WET 4 A P P LY A N D S M O O T H 5 TRIM AND FINISH Carefully measure the height and width of the glass surface. Cut the film to the dimensions, leaving an extra ½ inch to 1 inch around all sides. You’ll be able to trim the edges down to size in the final step. Thoroughly clean the surface of the glass to remove any trace of dust, grime and grease.