User guide

Eddy User's Guide
73
AT+SETESC,nn
Response OK
Purpose Change the escape sequence character
Description Escape sequence character set to ‘+’ by default is changeable.
The parameter nn must be a printable character.
Example AT+SETESC,42
ATO (ATOx, ATObdaddr)
Response None
Purpose Convert the operation status of ‘Standby’ to ‘Connect’
Description You can convert the operation status of ‘Standby’ to ‘Connect’ ready to transmit
data. In Node Switching mode, a specific slave can be specified to become an active
connection by specifying the connection number or the Bluetooth address.
Example ATO
ATO3
ATO000195000001
AT+BTCANCEL
Response OK
Purpose Terminate the current executing task
Description This terminates a current executing task, such as Inquiry scan and Page scan, then
converts the operation status to ‘Standby’
AT+BTSCAN
Response OK
CONNECT 112233445566
Purpose Wait for inquiry and connection from other Bluetooth devices
Description This allows the inquiry and connection from the other Bluetooth devices. The operation
status will be in ‘Pending’ after this command. When connection is made and
released, the operation status is back to ‘Pending’. To convert the operation status
to ‘Standby’ AT+BTCANCEL must be used.
This has the same effect as AT+BTSCAN,3,0.
When connection is made with other Bluetooth device, response will be ‘CONNECT’
with its BD address.