User guide

Eddy User's Guide
58
"ReadWrite.”
(Options : ReadOnly/ ReadWrite)
def v3username
[string]
eddy Configure the Username when use SNMP V3.
def v3password
[string]
none Configure the password when use SNMP V3.
def trapip
[address]
0.0.0.0
Configure the server IP address which receives the TRAP
information.
def trapoprt
[Socket No.]
162
Configure the server Port which receives the TRAP
information.
def trap_reset
[enable, disable]
Enable If Enable is selected, inform the "System reset info".
def trap_connect
[enable, disable]
Disable If Enable is selected, inform the "Serial Port opened info".
def trap_disconnect
[enable, disable]
Disable If Enable is selected, inform the "Serial Port Closed info".
def landhcp
[enable, disable]
Enable
If Enable is selected, DHCP server service will be enabled
on the LAN port.
def lanip <IP
Address>
10.10.1.1 Set the IP address on the LAN port.
def lanmask
<Subnet Mask>
255.255.255.0 Set the subnet mask address on the LAN port.
def lanstart <IP
Addrss>
10.10.1.2 Set the start address for the DHCP range on the LAN port.
def lanend <IP
Address>
10.10.1.30 Set the end address for the DHCP range on the LAN port.
def leasetime
<msec>
180 Set lease time for DHCP.
6.4 WiFi commands
Bellow are instruction and function which enable WiFi Network.
명령어 디폴트 설명
def wifi wireless
<Enable/ disable)
disable
Determine whether to use Eddy-WiFi module
det wifi mode
[infrastructure
/ ad-hoc]
infrastructure Configure the active mode of wireless LAN