INH Product Specification Shenzhen Intefly Electronics Co.,Ltd Tell: 0755-29126890 Web: www.intefly.
1. Product Introduction On the principle of eco-friendly and intelligent application, this integrated solar LED street light was born to solve the problem of highexpense electricity or lacking electricity in some areas, by using the solar power energy. Well-designed by our senior ID engineer, super-thin body design of 26mm thickness, detachable battery storeroom and RGB indicator makes it more artistic and easier to operate.
2.
3. Function characteristics PIR sensor: Check if somebody under the light through human infrared sensor, and adjust the brightness accordingly. Pathway indicator: Alert the drivers to pay attention by pre-indicating the front road status, especially in rainy or foggy days. APP control: Completely controlled by bluetooth APP, including turn on/off the light, read the light data and so on. Detachable battery storeroom: Easier to replace the battery or controller, no need to disassemble the light.
4.Product advantages Compared with LED street light Compared with other solar street light 1. Supplied by solar power energy, eco-friendly and no electricity charges; 2. DC12V power supply system, more safety than commercial electricity; 3. Easier installation, no buried cable; 4. Lower maintenance cost, all the problems will be found on smartphone APP; 5. All the lights are independent, won’t affect each other if any problems occur; 6.
5.Basic parameter:INH-40W Mechanical Specification LED Parameters Electrical Characteristic Rated Power 40W LED 42pcs 5050LED Light Body Size 1575*360*270MM Solar Panel 18V/90W Lumen Flux 10400-12000LM Weight 20KG Lithium Battery 519.
6.Applications Wide range of application, can satisfy the lighting requirement in most areas, the pathway indicator also can be another scenary of the urban infrastructure； Can be used in traffic road, highway, main street, outdoor parking lot, square and scenic spot etc.
FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference. (2)This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
