Installation Guide

INSTALLATION INSTRUCTIONS
R E A D I M P O R T A N T S A F E T Y T I P S B E F O R E P R O C E E D I N G W I T H I N S T A L L A T I O N
Turn fixture off! (Place wall switch
in off position, if fixture has built-in
switch or chain pull, switch or pull
chain so fixture is off.)
Next - go to the main fuse box. If
your fuse box has an ON/OFF switch,
simply place main power switch in
OFF position.
SAFETY TIPS
Screw-in type fuses - unscrew the fuse
or fuses that control the power to the
fixture or room you are working in.
1
CONNECT THE WIRES. NOTE: Attach the black
fixture wire to the black supply wire, the white fixture
wire to the white supply wire. Do not mix them up.
Use approved wire connectors (not provided).
Connect bare fixture ground wire to supply ground.
NEVER CONNECT GROUND WIRE TO BLACK OR
WHITE POWER SUPPLY WIRES.
wire connectors
(not provided)
post
(not provided)
ground wire
2
POSITION THE FIXTURE over the post as shown. For
permanent mounting, fasten with screw at hole in post
collar by drilling hole at same location through post and
securing with screw.
screw
(provided)
post
(not provided)
post
collar
3
Screw light bulb into socket. Be sure to
use bulb type and wattage specified on
fixture.
IS52TFINC
CLEAN ONLY WITH MILD SOAP AND WATER. AVOID SPRAYING WITH CLEANSERS,
INSECTICIDES, AND PESTICIDES THAT ARE PETROLEUM BASED HYDROCARBON
PRODUCTS. THESE WILL DEGRADE LUMINAIRE.
roof
S52TF
twist to
open
Grasp roof and rotate clockwise until
- shaped tabs on roof align with
- shaped opening in top of fixture and
remove roof. Install bulb and attach roof.
NOTE: FIXTURE IS PROVDED WITH A
TAMPER PROOF SCREW TO PREVENT
REMOVAL OF ROOF.