Instructions / Assembly

IS99-S071
IS99-
S071
Clean only with mild soap and water. Avoid spraying with cleansers, insecticides and pesticides that are petroleum based
hydrocarbon products. These will degrade luminaire.
1 2
ATTACH BLACK FITTER WIRE to the black supply wire, white
fitter wire to the white supply. Use wire connectors (not
provided). Connect bare fitter ground wire to the ground wire
from the power supply. REMOVE GLOBE: slide fitter to side of the globe and lift out.
POSITION THE FITTER over the post as shown. Tighten the
locking screws. Install light bulb into socket. Be sure to use
bulb with wattage no greater than specified for this fixture.
ATTACH GLOBE TO FITTER. Slide edge of globe between filler
and one flange. Push other flange into globe. Center globe
on fitter. Tighten two fitter screws to secure globe to fitter.
wire connector
(not provided)
ground wire
post
(not provided)
locking screws
fitter
globe
fitter screws
fitter
43
globe
fitter screws
fitter
INSTALLATION INSTRUCTIONS
REA D IMPO RTANT SAFETY TIPS B EFORE PRO CEEDING WITH INS TALLATIO N
Turn fixture off! (Place wall switch
in off position, if fixture has built-in
switch or chain pull, switch or pull
chain so fixture is off.)
Next - go to the main fuse box. If
your fuse box has an ON/OFF switch,
simply place main power switch in
OFF position.
SAFETY TIPS
Screw-in type fuses - unscrew the fuse
or fuses that control the power to the
fixture or room you are working in.
OR
OUTDOOR POST FIXTURE
Clean only with mild soap and water. Avoid spraying with cleansers, insecticides and pesticides that are petroleum based
hydrocarbon products. These will degrade luminaire.
1 2
ATTACH BLACK FITTER WIRE to the black supply wire, white
fitter wire to the white supply. Use wire connectors (not
provided). Connect bare fitter ground wire to the ground wire
from the power supply. REMOVE GLOBE: slide fitter to side of the globe and lift out.
POSITION THE FITTER over the post as shown. Tighten the
locking screws. Install light bulb into socket. Be sure to use
bulb with wattage no greater than specified for this fixture.
ATTACH GLOBE TO FITTER. Slide edge of globe between filler
and one flange. Push other flange into globe. Center globe
on fitter. Tighten two fitter screws to secure globe to fitter.
wire connector
(not provided)
ground wire
post
(not provided)
locking screws
fitter
globe
fitter screws
fitter
43
globe
fitter screws
fitter
INSTALLATION INSTRUCTIONS
READ IMPORTA N T S AFETY TIPS BEFORE PROCEEDING WITH INSTALLATIO N
Turn fixture off! (Place wall switch
in off position, if fixture has built-in
switch or chain pull, switch or pull
chain so fixture is off.)
Next - go to the main fuse box. If
your fuse box has an ON/OFF switch,
simply place main power switch in
OFF position.
SAFETY TIPS
Screw-in type fuses - unscrew the fuse
or fuses that control the power to the
fixture or room you are working in.
OR
OUTDOOR POST FIXTURE