Instructions / Assembly

Direct Burial Lamp Post Installation Guide
fixture
(not included)
gravel
cross arm
(optional)
convenience outlet/
photo control
(optional)
Dig a hole 12” -
15” in diameter to
the depth shown
in the diagram to
the left. Consult
local codes.
Dig an addtional
6” depth and
pour in 6” of
gravel for drain-
age purposes.
Dig trench from
power source to
lamp post hole.
Check local
codes for trench
depth.
PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING FIXTURES.
CAUTION: DISCONNECT POWER AT THE BREAKER BOX BEFORE BEGINNING INSTALLATION
TURNING OFF POWER AT THE SWTICH ALONE IS INADEQUATE TO INSURE YOUR SAFETY
FAILURE TO PROPERLY DISCONNECT THE MAIN POWER SUPPLY MAY RESULT IN SERIOUS INJURY
• We strongly recommend that you check your local wiring codes and consult an electrical contractor before installing post.
• We do not guarantee this method of installation satises your particular local building codes. Call local municipality.
• Before starting any digging project, call 811 to prevent against unintentionally hitting any underground utility lines.
SAFETY NOTE: Selecting a post for performance and safety requires a full understanding of various factors and conditions.
Professional engineering assistance in selecting a post is highly recommended. Purchaser is responsible for meeting any and all
codes or requirements. If you choose a post without getting such assistance, you do so at your own risk.
power line
cement/
gravel
trench to
power source
inlet hole
inlet hole
1
2
3
4
5
Lay pole on ground and feed power line (not included) beginning through the inlet hole to top
of pole. Allow 10” of extra wire at top of pole and leave remainder of wire at the bottom for
connection to power source.
Place pole in center of hole and ll
with gravel or cement to just below
the inlet hole as shown below. Check
local codes.
Run the remainder of the power line
through trench to connect to power
source.
Bury the power line and pole base.
Connect convenience outlet, photocell, and xture, if purchased. (Wire nuts not included)
NOTE: IF YOU PREFER THE CONVENIENCE OUTLET TO BE CONTROLLED BY
PHOTOCELL, CONNECT PHOTOCELL FIRST.
Insert crossarm, if purchased.
Turn on power.
fixture
(not included)
connect wires
black to black
white to white
ground to ground
FIXTURE
BLACKBLACK
WHITEWHITE
GROUND WIRE
GREEN OR BARE
GROUND WIRE
GREEN OR BARE
WIRE NUT OR OTHER
ACCEPTABLE CONNECTOR
120V POWER SUPPLY
LIGHT FIXTURE
CONVENIENCE OUTLET
inlet hole
wire
10”
gravel/cement
PHOTOCELL
FIXTURE
120V SUPPLY