User Guide

25
75KAV/75KAV-X
3.3V (default)
JP10/JP11: MEMORY MODULE VOLTAGE SELECT
1 3
1 3
JP10
JP11
3.4V
1 3
1 3
JP10
JP11
3.5V
1 3
1 3
JP10
JP11
3.6V
1 3
1 3
JP10
JP11
This function allows you to select the voltage supplied to the
DRAM. The default voltage (3.3V) should be used unless
processor overclocking requires a higher voltage.
NOTE! Using a higher voltage may help when overclocking
but may result in the shortening of your computer
components’s life. It is strongly recommended that you
leave this setting on its default.
Clear CMOS Data
Retain Data (default)
JBAT1: CLEAR CMOS DATA
JBAT1
1 3
JBAT1
1 3
A battery must be used to retain the motherboard configuration
in CMOS RAM.
NOTE : You can clear CMOS by shorting 2-3 pin when the system is
POWER OFF. Then, return to 1-2 pin position (default). It
may damage the motherboard if clearing the CMOS in
POWER ON status. Unplug the power cord from power
supply before clearing CMOS will be a best bet for user.
2-8.6 MEMORY MODULE VOLTAGE SELECT (JP10/JP11)
2-8.7 CLEAR CMOS DATA (JBAT1)