User Guide

18
75KAV/75KAV-X
SOCKET A
FLASH BIOS
VIA
KT-133A
VIA
686B
ATX POWER
SW1
LPT1
COM 1
GAME/MIDI PORT
LINE OUT
LINE IN
MIC
USB2
AC'97
Codec
Li
Battery
ISA
J3 J4
SPK RST PWR/LED T/LED
HDD/LED IR PWR SMI
++
--
+
-
1 15 1 15
AGP PRO 4x
PCI 1
COM 2
PCI 2
PCI 3
PCI 4
PCI 5
FDD1
IDE2
IDE1
DIMM1 DIMM2 DIMM3
14
14
1 3
1 3
1 3
1 3
JBAT1
JP7
JP1
JP2
1 3
JP9
PC100/PC133 SDRAM
WOL1
CD_IN2
CD_IN1
FAN2
W5280
FAN1
JP3
RT2
SSF1
ZD1
1 3
1 3
JP10
JP11
ON
DIP
5 4 3 2 1
Clock
Generator
SW2
USB1 USB0
PS/2 MOUSE PS/2 K/B
upper
lower
upper
lower
ON
DIP
4 3 2 1
1
16
2-4 HDD / FDD INSTALLATION
• To install HDD (Hard Disk Drive), you may connect the cable’s blue
connector to the motherboard’s primary (IDE1) or secondary IDE
connector, and then connect the gray connector to your slave device
and the black connector to your master device.If you install two hard
disks , you must configure the second drive to Slave mode by setting
its jumper accordingly.Please refer to your hard disk documentation
for the jumper settings.
• To install FDD (Floppy Disk Drive), you may connect the single end to
the board , and connect two plugs on the other end to the floppy drives.
Floppy Disk Drive
Connector:
Orient the red markings
on the floppy ribbon
cable to Pin1.
Hard Disk Drive
Connector:
Orient the red markings
on the IDE ribbon cable
to Pin1.