Instruction Manual

13 UM0039_Ai-LB 5k_EN_V01_0223
shims to level the unit in floor-mount configurations. Do not use other hardware to anchor Power Box to the
floor.
3.2 Tools
The tools in the following table could be needed during the installation
Torque screwdriver
Phillips-screwdriver bit
Hex-key bit
Phillips-head screwdriver
Torque wrench
Wrench
Cylinder screwdriver bit
Scissor
tie
level
Electric Drill
Tape measure
Hammer
Twist drill
Marker pen
3.3 Safety Gear
Wear the following safety gear when dealing with the battery system.Installation personnel must meet the
relevant requirements of international standards.