Quick start Guide

1
2
!
IMPORTANT
!
IMPORTANT
1
!
IMPORTANT
32
Micro SD Card Docking the Camera Powering On
3
Create an Account Update Tag Registration
Dock the OpticX Camera to the Base by
guiding it down onto the tilt drum from
above, and then pushing it forward until
it securely clicks into place.
Preparing your SOLOSHOT3
Insert an approved Micro SD Card into
the side of the OpticX Camera.
You will hear a click when fully inserted.
To power on Base, press and hold the
Power Button for 3 seconds.
To power on Tag, press the Power
Button.
Create a SOLOSHOT account at
app.soloshot.com.
Power on the Base and follow the
on-screen instructions to update your
device.
!
IMPORTANT
Your SOLOSHOT3 must be upright and
level upon start-up and updating
software.
It’s recommend it be connected to a
tripod during this process.
The screen will be blank for up to one
minute during certain steps of the
update process.
Do not power down device during
update.
After registering your Tags, you are
prompted to select the tracking
preferences of the Tag.
USER MANUAL 04 SOLOSHOT.COM
A SOLOSHOT account is required before
setup of your SOLOSHOT3.
Preparing Your SOLOSHOT
Preparing your SOLOSHOT3
Your SD card will be completely erased.
Make sure to save any content that you
don’t want erased!
Visit support.soloshot.com for a list of
compatible SD cards.
Update and Registration