User's Guide

Brama S-C / S-A1 User Guide
© Interlink-U, 2021 Page 5 of 26
3. Initial Set Up and Care and Maintenance
3.1 Initial Set Up
3.1.1 What’s included
The box containing your Brama Device includes the following items:
• Brama S-C or S-A1 device
• Charger and cable (including adapter for your region)
3.1.2 Initial Charge of your Brama Device
Your Brama Device must be fully charged before you attempt to use it; this conditions the battery fully.
We recommend leaving the device on charge for a minimum of 2-3 hours the first time you charge it,
and that it is only charged using the supplied charger.
3.2 Care and Maintenance
Brama Devices are purposely designed so that you do not need to perform any routine maintenance.
However, you should note the following points about cleaning and general care.
3.2.1 Cleaning
Use a damp cloth (not wet) to remove any dirt from your Brama Device. Be very careful not to allow
water into the unit.
Ensure the cloth is clean from grit or dirt when cleaning the camera lens as this could scratch the device
lens.
Do not use any alcohol or chemical cleaning agents of any type.
3.2.2 Moisture Resistance
Brama Device is water resistant and can survive short lengths of submersion in shallow depths of
water, less than 1m.
3.2.3 Impact Damage
Brama Devices are made from a tough ABS plastic case. It is designed to resist a certain amount of
damage typical with general use, but the device will not withstand heavy impacts.