Operation Manual

5 Maintenance, cleaning and storage / 6 Standard delivery

ENGLISH 10

5.7 Maintenance plan

Before you start working

After work

When changing the spraying agent

On demand

Monthly

Annually or at the start of the season

Entire pressure sprayer

Check whether the device is safe to use:

x Visual inspection of the device

x Check the tightness of all equipment compo-

nents (at maximum permissible pressure with

open and closed shut-off valve)

x Check the function of all active components

(pressure relief valve, shut-off valve, pump

handle, pressure gauge (depending on the

model))

Hoses and their screw

connectors

Visual inspection X

Spraying agent tank Visual inspection X

Clean (section 5.5) X X

Nozzles and

filter element

Clean (section 5.5) X X X

Trial run to check the spray nozzles and the

filter element by measuring the delivery rate

(section 5.2)

X*: A monthly trial run is required only if the

device is used frequently.

X X* X

Cap gasket Grease (section 5.4) X X

Never start working if there are any irregularities or leaks, if you can see any damage to the equipment or

if the equipment is not working properly in any way. In this event, immediately depressurise the device by

pulling on the pressure relief valve (Fig. 4) and have it checked by a specialist workshop.

Before pulling on the pressure relief valve (2), the device must always be in an upright position.

Attention: Keep the device away from your face!

If you have any questions please refer to your authorised SOLO dealer.

6 Standard delivery

x Standard device with shut-off valve assembled on the high-pressure hose

x Spray tube with assembled nozzle attachment

x These operating instructions (incl. EC declaration of conformity)