Installation Guide

8
INSTALLATION INSTRUCTIONS
Before using your wine / beverage coolers
−
Remove the exterior and interior packing.
− Check to be sure you have all the following parts:
o Shelves
o 2 Keys
o Stainless Steel Handle
o Instruction Manual
− Before connecting your new wine / beverage cooler to a power source, let it stand upright for approximately
12 hours. This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
−
Clean the interior surface with lukewarm water using a soft cloth.
−
Install the handle on the left side of the door.
Installation of your wine / beverage cooler
− These wine / beverage coolers are designed to be used with free standing installation or built-in installation.
−
Place your wine / beverage cooler on a floor that is strong enough to support it when it is fully loaded. To
level your wine cooler, you can adjust the front leveling legs at the bottom of your wine / beverage cooler.
− Place the wine cooler away from any direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct
sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold
ambient temperatures may also cause the unit not to perform properly.
− Avoid installing / setting up the unit into moist or potentially moist areas.
−
Plug the wine / beverage cooler into an exclusive, properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power
and/or grounding should be directed toward a certified electrician or an authorized Products service center.
Electrical connection
Warning: Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is
damaged, have it replaced by an authorized service center.
These wine & beverage coolers should be properly grounded for your safety. The power cord of this appliance
is equipped with a three-prong plug which mates with standard three prong wall outlets to minimize the
possibility of electrical shock.