Installation Guide

14
Shelves
The racks of some of our wine and beverage cooler models are equipped with a telescopic runner assembly
(except for the bottom shelves, the BIWC-120-2D). This allows you can move the wooden shelves in and out
smoothly with little resistance, maximizing usage efficiency and the overall lifespan of your product.
To prevent damaging the door gasket, please make sure to have the door(s) all the way open when pulling each
of the shelves out of the rail compartment. For easy access to the bottles, you must pull the shelves
approximately 1/3 out of the rail compartment.
To remove the shelves out of the rail, pull each shelf approximately 1/3 out. Use a long flat screwdriver to press
down the right plastic notch as shown in Figure A and at the same time lift the left plastic notch as shown in
Figure B. Then proceed to pull out the shelf slowly.
Figure A Figure B
●
To remove the shelves out of the CABINET without a telescopic runner, you can pull out the shelf
to the shelf holder position, then lift the shelf to remove the shelf. (See figure below)
To avoid the damage of door sealing, please open the door fully when you slide out the shelves.
● For your convenience of taking wine, you can pull out the shelf by 1/3. Our product is designed
with shelf holder to prevent the shelf pull over and fall off the cabinet.