INSTRUCTION MANUAL WINE COOLER MODELS: BIWC-100B / BIWC-100D BIWC-150B / BIWC-150C / BIWC-150D BIWC-120-2D
TABLE OF CONTENTS WINE / BEVERAGE COOLERS SAFETY 2 IMPORTANT SAFE-GUIDES 3 REFRIGERANT GAS WARNINGS 4 UNIT BREAKDOWN PT.1 5 UNIT BREAKDOWN PT.2 6 UNIT BREAKDOWN PT.3 7 INSTALLATION INSTRUCTIONS PT.1 8 INSTALLATION INSTRUCTIONS PT.2 9 INSTALLATION INSTRUCTIONS PT.
WINE CHILLER SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the Safety Alert Symbol. This symbol alerts you to potential hazards that can kill, maim, injure, or damage you and others. All safety messages will follow the Safety Alert Symbol and either the words “DANGER”, “WARNING” or “CAUTION”.
IMPORTANT SAFEGUIDES Before the appliance is used, it must be properly positioned and installed as described in this manual, so read the manual carefully.
The symbol is a warning symbol for risk of fire/flammable material. WARNING: When positioning the appliance, ensure the supply cord is not trapped or damaged. WARNING: Do not locate multiple portable socket-outlets or portable power supplies at the rear of the appliance. Use two or more people to move and install appliance. Failure to do so can result in back or other injury. To ensure proper ventilation for your appliance, the front of the unit must be completely unobstructed.
refrigerant used. CAUTION - Risk of fire or explosion due to puncture of refrigerant tubing. Follow handling instructions carefully. Flammable refrigerant used. CAUTION - To prevent a child from being entrapped, keep out of reach of children and not in the vicinity of the cooler.
BIWC-100B,D/BIWC-150B,D (Dual Zone) 1 Control Panel 5 Top Hinge 2 Wooden Shelves 6 Glass Door with Handle 3 Kick Plate Vent 7 Child Safety Lock 4 Adjustable Legs 6
BIWC-150C (Single Zone) 1 Control Panel 5 Glass Door with Stainless Steel Trim 2 Handle 6 Child Safety Lock 3 Wooden Shelves 7 Kick Plate 4 Door Hinge 8 Adjustable Legs 7
INSTALLATION INSTRUCTIONS Before using your wine / beverage coolers − Remove the exterior and interior packing. − Check to be sure you have all the following parts: o Shelves o 2 Keys o Stainless Steel Handle o Instruction Manual − Before connecting your new wine / beverage cooler to a power source, let it stand upright for approximately 12 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation.
Do not under any circumstances cut or remove the third ground prong from the power cord supplied. For personal safety, this appliance must be properly grounded. This appliance requires a standard 115V/60Hz electrical ground outlet with three-prong. Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded.
Installing the stainless-steel handle Your wine / beverage cooler includes a stainless-steel handle. To install the handle please follow the below instructions: 1. Pull away the door gasket in the area where the handle is to be installed on the left side as shown below in Illustration # 1. The gasket is easily displaced by hand, no tools are necessary. 2. Align the handle with the screws installed.
CARE AND MAINTENANCE Moving your wine / beverage cooler -Remove all items (bottles) -Tape down securely all loose items (shelves) inside your appliance. -Turn the adjustable leg up to the base to avoid damage. -Tape the door shut. Be sure the appliance stays secure in the upright position during transportation. If you absolutely need to transport the chiller horizontally, transport the chiller on its back (door on top). Also protect outside of appliance with a blanket, or similar item.
OPERATING YOUR WINE COOLER It is recommended you install your wine / beverage cooler in a place where the ambient temperature is between 19ºC-24ºC (66ºF-75ºF), and humidity is under 60%. If the ambient temperature is above or below recommended temperatures, the performance of the unit may be affected. For example, placing your unit in extreme cold or hot conditions may cause interior temperatures to fluctuate.
BIWC-100B,D/BIWC-150B,D : Temperature setting range： BIWC-100B/BIWC-150B: upper zone 40-50℉ (5-10℃); lower zone50-66℉ (10-18℃) BIWC-100D/BIWC-150D: upper zone 38-50℉ (3-10℃): lower zone50-66℉ (10-18℃) Turn on/off the blue interior lights Press and hold for 3 seconds, Toggles the temperature display between Celsius and Fahrenheit Press to begin adjusting the temperature for upper or lower zone Adjusts the temperature in 1 degree increments or decrements Press and hold for 3 seconds to turn on /off the a
Shelves The racks of some of our wine and beverage cooler models are equipped with a telescopic runner assembly (except for the bottom shelves, the BIWC-120-2D). This allows you can move the wooden shelves in and out smoothly with little resistance, maximizing usage efficiency and the overall lifespan of your product. To prevent damaging the door gasket, please make sure to have the door(s) all the way open when pulling each of the shelves out of the rail compartment.
Power failure Most power failures are corrected within a few hours and should not affect the temperature of your appliance if you minimize the number of times the door is opened. If the power is going to be off for a longer period, you need to take the proper steps to protect your contents. Moving your wine / beverage cooler - Remove all items (bottles) Tape down securely all loose items (shelves) inside your appliance. Turn the adjustable leg up to the base to avoid damage. Tape the door shut.
Charcoal filtration system You could say that your wine is alive and breathes through the cork of its bottle. In order to consistently maintain the wine’s quality, purity, and taste the corks must be stored at an ideal temperature with ambient conditions. This allows the cork to maintain a maximum lifespan and preserve the finest of beverages inside. To help accomplish this your cellar is equipped with an active charcoal filtration system to ensure air purity and cooling efficiency.
TROUBLESHOOTING GUIDE You can solve many common wine / beverage cooler problems easily, saving you the cost of a possible warranty inquiry. Try the suggestions below to see if you can solve the problem before calling us. PROBLEM POSSIBLE CAUSE Not plugged in. chiller does not operate. chiller is not cold enough. SOLUTION Plug the unit. The appliance is turned off. The circuit breaker tripped or a blown fuse. Press power button to turn on the unit. Check the breaker and/or fuses.
Level the chiller. The chiller seems to make too much noise. The rattling noise may come from the flow of the refrigerant, which is normal. As each cycle ends, you may hear gurgling sounds caused by the flow of refrigerant in your chiller. Contraction and expansion of the inside walls may cause popping and crackling noises. The chiller is not level. The chiller is not level. The door will not close properly. Level the chiller. The door was reversed properly installed.
