User's Guide

11
7
Hardware specifications
Model number: IFC-MLU-JC-H
Dimensions: about 140mm (L) x 95mm (W) x 45mm (H) * without extension
Quality: approximately 340g
Operating temperature: -5-40°C
Working humidity: 10-80%RH
Interface: USB2.0 Type-A
current consumption:
Input voltage: 15V 3A
Output voltage：12V 2A
Maximum communication current consumption: TBD (about [550] mA) or less
Average current consumption during communication: TBD (about [300] mA) or less
Average standby current consumption: LTE: about [30] mA or less, TBD
Supported SIM card shapes: nanoSIM
LTE: Supported frequencies of 1.7 GHz, 1.8 GHz, 2.5GHz
Compatible with frequency bands B2, B4, B41
Data rate: LTE Cat.4 The highest downside is 150Mbps and the highest downside is 50Mbps Wireless
LAN: IEEE 802.11 b / g / n
The 2.4 GHz frequency band
Safety: WPA2-PSK (AES) TBD
The communication speed is the technical maximum value when sending and receiving, and does not
represent the actual communication speed. It will be provided in the best possible way, with the
actual speed varying depending on your communication environment, network congestion conditions,
and your SIM service contract
8 FCC warning:
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm between
the radiator & your body.