Installation Guide

WWW.SOLISTONE.COM
wet application and the back of the tile has nylon mesh glued to it, it is recommended that you
lightly score the back of the tiles diagonally in a grid pattern with a masonry grinder. Stay ¼”
away from the perimeter edge of the tile when doing this. In addition, it will be necessary to
back-butter the product with the flat edge of a trowel. This process will ensure that each
individual tile will adhere to the surface and guarantee longevity of the product in a wet
application.
GROUTING
If you are doing a butt-joint installation, grout may not be necessary. Grout should be designed
for external or internal conditions whichever may be the case. If you are leaving a grout joint
1/8” or smaller, non-sanded grout is recommended.
SEALANTS
To prevent possible staining and discoloration, we recommend sealing all marble tiles BEFORE
installation, and if using grout, AFTER the grouting process.
BEFORE applying sealant, wash the tiles and let dry for 24-48 hours. This will ensure that moisture
is not present under the surface of the tile. Failure to allow tiles to dry completely before
application will result in permanent discolorations. We recommend testing all sealants on a single
tile before application. There are various products available on the market, however, we
recommend contacting your nearest tile supplier for the most appropriate sealer for your
application.
CARE & CLEANING
SOLISTONE Haisa Marble tiles must be regularly cleaned and maintained to extend the life and
beauty of the tile. The tiles can be cleaned with a neutral mild detergent, or a PH neutral cleaner.
Staining may occur if the tile is left unsealed. Consequently, any spills should be cleaned quickly
to lessen the degree of the stain. For tiles in high traffic areas keep surfaces clean from abrasive
dirt. Do not use abrasive cleaners, powders, scouring pads, steel wool or sandpaper. Do not let
soap, bleach or other cleaning solutions set on the surface.