Installation Guide

WWW.SOLISTONE.COM
The manufacturer's literature will explain if the adhesive product is suitable for interiors
and/or exteriors, as well as walls and floors. Most thinset mortars (multi purpose and
polymer modified thinsets) are adequate for installing standing pebbles. A cement-based
adhesive is generally suitable on masonry substrates where no movement is anticipated.
Where slight movement could occur through thermal or pedestrian loads, a modified cement
adhesive should be used as a minimum. A 1/4” square notch trowel is recommended for most
applications. Use a gray or tinted thinset mortar if you are using the dark pebbles, and a
white thinset for lighter colors. It is very important that each pebble is embedded in the
adhesive.
GROUTING
Generally, grout is not necessary for the installation of the Standing Pebble tiles. For some
flooring applications, such as borders or floor accents where grout may become necessary, grout
should be suitable for joints up to 3/4" in width and designed for external or internal conditions
which ever may be the case. Sanded grout is generally recommended for any grout joint larger
than 1/8”. Grouts are ordinarily water mix but where some flexibility may be needed, a latex
additive or similar product should be used. It is important to wait the interval recommended by
the adhesive manufacturer before grouting to minimize dirt ingress between the pebbles and
avoid the opportunity for dislodging of the pebbles.
In the event that one desires to better expose the pebbles, it is suggested that during the grouting
process, the installer repeatedly removes the excess grout from the joints by the use of a medium
bristle brush and sponge. During this process, it is also recommended that, if necessary, the excess
grout is carved from the edge of the pebbles by use of an appropriate knife.
SEALANTS
Depending on the nature of use, sealers may or may not become necessary. We do not
recommend sealers for water features or some outside walls. However, there are various products
available on the market and we recommend contacting your nearest tile supplier for the most
appropriate sealer for your application. Whenever using sealants and acids, please ensure that
you follow the manufacturer’s recommended method of application.
CARE & CLEANING
SOLISTONE Standing Pebble mosaics must be regularly cleaned and maintained to extend the
beauty of the tile. The pebbles can be cleaned with a neutral mild detergent. The porosity or
water absorption in pebbles varies and therefore staining will occur in different degrees if the
stone is left unsealed (this may be a desired effect). Consequently, any spills should be cleaned
quickly to lessen the degree of the stain.