Instructions

Solinst Canada Ltd. 35 Todd Road, Georgetown, Ontario Canada L7G 4R8 www.solinst.com
E-mail: [e-mail] Tel: [phone] Fax: [phone]
December 6, 2021
(#116058) (Page 3 of 3)
Power Winder Periodic Maintenance
The 3/32" Allen key that is supplied with the Power Wind-
er should be used to tighten all of the fasteners on the Power
Winder that could become loose over time. This includes the set
screws in the rollers, the four set screws on the swing arm and
the fasteners on the base of the Power Winder. No lubrication
is used, anywhere.
Using the Optional Flex Drill Adaptor (#116199)
For easier access to the 1/4” hex fitting on the Power Winder,
a Flex Drill Adaptor is available so you can operate the Power
Winder using your drill/driver at any angle.
1. To connect the Adaptor, push the collar fitting forward and
slide onto the Power Winder hex fitting and release.
2. Connect your drill/driver to 1/4" hex fitting on the other
end of the Adaptor, and operate as described in the previous
section. Remove the drill from the Adaptor when finished.
3. To remove the Adaptor, pull the collar fitting back and slide
off the hex fitting on the Power Winder.
Using the Optional Cinch Straps (#116059)
A set of cinch straps is available for adding to the base of the
Power Winder, to allow you to secure the Power Winder to a
well casing or for use in another application.
1. To connect the cinch straps, thread them through the base
of the Power Winder as shown in the photo above.
2. To use the straps, insert the end of the strap into the
backside of the buckle and push it through the buckle lever.
Pull the strap to tighten it.
3. To release the straps, push down on the lever of the buckle
and pull the strap through.