User Guide

5-axis MachiningSolidCAM2005 Milling Manual
4
9.3.4 Tool axis will be tilted with fixed angle to axis ............................................................ 114
9.3.5 Tool axis will tilted around axis ...................................................................................
115
9.3.6 Tool axis will be tilted through point ...........................................................................
116
9.3.7 Tool axis will be tilted through curve ...........................................................................
117
9.3.8 Tool axis will be tilted through lines .............................................................................
123
9.3.9 Tilted from point away ................................................................................................. 123
9.4 Side tilt definition .............................................................................................................. 124
9.5 Tool axis direction limit parameters ..................................................................................
125
9.5.1 XZ Limit ....................................................................................................................... 126
9.5.2 YZ Limit ....................................................................................................................... 126
9.5.3 XY Limit: ..................................................................................................................... 127
9.5.4 Conical angles from leading curve .............................................................................. 127
10. Gouge Check page ............................................................................................................ 128
10.1 Clearance ....................................................................................................................... 128
10.2 Check gouge between positions .................................................................................... 129
10.3 Gouge pages .................................................................................................................. 131
10.4 Tool .................................................................................................................................
131
10.4.1 Tool Tip and Tool Shaft .............................................................................................
131
10.4.2 Check Arbor and Check Holder ................................................................................ 132
10.5 Strategy .......................................................................................................................... 132
10.5.1 Retracting tool along tool axis ................................................................................... 133
10.5.2 Moving tool away ...................................................................................................... 134
10.5.3 Tilting tool away with max angle ............................................................................... 141
10.5.4 Leaving out gouging points ....................................................................................... 143
10.5.5 Stop tool path calculation .......................................................................................... 143
10.6 Drive Surfaces ................................................................................................................ 144
10.7 Check Surfaces .............................................................................................................. 144
10.8 Stock to leave ................................................................................................................. 144
11. Stock Page .........................................................................................................................
145
12. Additional parameter Page .................................................................................................
146
13. Appendix ............................................................................................................................ 147
13.1 Single Surface versus Multi Surface Machining in 5 Axis .............................................. 147
13.2 At the beginning of all: Single Surface 5 Axis Flowline .................................................. 147
Document number: SC5AUG06001