User Guide

5-axis MachiningSolidCAM2005 Milling Manual
34
Exercise 6:
1. Load the CAM-Part: Exercises\Cut_control\impeller.prt
2. Create a new 5-Axis Operation using the Morph between two curves strategy.
This option is used due to the inequality of the distance between the upper and
lower curves of the blade.
3. Define the Drive Surface as shown.
4. Select the model edge
for the Upper Edge
curve geometry as
shown.
Make a note to select the geometry accurately without gaps. The accurate
selection results in a more accurate tool path without tool jumps.