User Guide

SolidCAM2005 Milling Manual
23
5-axis Machining
Exercise 1:
1. Load the CAM-Part: Exercises\Cut_control\parallel_cuts.prt
2. Simulate the operations and check the parameters used to control the Machining
angles for the Parallel Cuts strategy.
3. Add operations for the machining of other cylinders. Use the
Parallel Cuts
strategy and define the necessary parameters in order to cut the cylinder normal
to the direction of the center line.
4. In order to cut the cylinder and the top face you have to use a different angle
(inclination). Create some operations to practice this task.