User Guide

SolidCAM2005 Milling Manual
143
5-axis Machining
10.5.4 Leaving out gouging points
Activating this option will cause the tool path to be trimmed when a
collision is detected.
10.5.5 Stop tool path calculation
If you select the option Avoid by leaving out the tool, the tool path will be created only until the first
gouge is detected.
Here you can see that the next cut
would cause contact with the check
surface. The tool path was created
until the stop position.
Check surface
Drive surface
Stop position
Check surface
First gouge
Tool path