User Guide

5-axis MachiningSolidCAM2005 Milling Manual
114
9.3.3 Tool axis will be tilted with the angle
Simulate the appropriate Operation
of Exercise9. The CAM-Part is
located in the Exercises\Tilting_
strategies folder.
In the above case, the tool axis is
tilted 45 degrees from the surface
normal direction towards the Y axis.
9.3.4 Tool axis will be tilted with fixed angle to axis
Simulate the appropriate Operation of Exercise9. The CAM-Part is located in the Exercises\Tilting_
strategies folder.
The tool axis is tilted 15 degrees towards the main Z axis.
Tilt Axis
Tool Axis
Surface Normal
45°
Z Axis
Tool Axis
15°